The most common errors of Miele washing machines | Coolblue (2024)

Do you see F63 on the display? If so, there's too much foam in the drum and you may have used too much detergent. Empty the drum completely and run a cotton program at 90°C. Don't use detergent. This way, you can remove excess soap residue. To prevent this, always dose your detergent and fabric softener according to the label on the bottle so you don't use too much.

If you see this error code or notification on the display, there's a problem with the water supply. It means that there's not enough water getting into the drum, or no water at all. A possible solution is to open the water supply completely. Then, check whether there's a blockage or kink in the supply hose. Is the hose broken? Replace it. Turn on the wash cycle again and check if the error is solved.

This error message indicates that there's a short circuit in the sensor of the TwinDos system. Do you see this code? Dose your laundry detergent and fabric softener manually via the detergent drawer at the top of the washing machine. Contact Miele and have the sensor checked or replaced.

You see the notification 'Place TwinDos reservoir', even though the TwinDos bottles are placed correctly. it could be that the detergent clumped if you haven't used the washing machine in a while. If that's the case, the dosing system doesn't work. Remove the flacons and rinse the TwinDos system with the TwinDos Care maintenance product. This way, you can rinse the tubes. Put in new flacons and start the washing machine again.

The washing machine isn't pumping out the water, which is why the drum is full of water. It could be that the drain filter is clogged. You can check this via the hatch on the front, at the bottom left. To prevent dirt from falling onto your floor, put down a towel to be safe. If there's a hairpin of coin in the filter, take it out. In the article below, you can reach what to do to unclog the rest of the drain.

Do you see the 'waterproof' notification of a faucet symbol? The leak protection system indicates that there's a leak somewhere. The leak could be in the supply hose, the drum, or the bottom of the washing machine. When you see this error, you should close the water supply or unplug the connector from the socket right away. After that, contact the the vendor you bought your washing machine from or contact Miele.

Does you washing machine show an error, but doesn't your old Miele washing machine have a display? You can recognize the error by a combination of lights on the washing machine. Please contact Miele for a solution. They'll help you find the cause of the problem.

If you see a different malfunction or error code, check the manual of your Miele washing machine. Wasn't the problem solved? Unplug the connector from the socket for about 30 minutes, then try to restart the cycle. If that doesn't work either, you probably need a technician. Did you buy your washing machine at Coolblue and is it still under warranty? Contact our customer service. Is that not the case? Contact the vendor or Miele.

Submit your feedback

Help after purchasing a Miele washing machine

How do you use Miele TwinDos?

Hoe do you set up your Miele washing machine with WiFI?